This section contains all general help/support needed for the internal reader of the archer 1. these internal readers are no longer being made.
If you still cannot find what you are looking for, try the search engine in the top left corner of the screen. If you would prefer to talk to a customer support representative, please call 1-435-760-7688 or e-mail Karl Calderwood.
RFID Reader Installation
This instruction page shows how to install the RFID reader card into an Archer that has been purchased by a customer after the Archer has shipped. This card will not work without connecting to the Fort Supply server and downloading the appropriate drivers. Please contact Fort Supply with any question.
NOTE: To Begin first make sure you have both an extended cap, and the required piece of foam.
This foam is about ~1.75x.75x.5" (4.5x1.5x1cm)
NOTE: If the user has ANY questions, STOP and contact a Fort Supply employee. (435-760-7688)
Steps for Installation.
1) Insert foam into bottom of cap. Make sure it is pressed down firmly in the bottom of the cap.
2) Make sure RFID Reader is oriented correctly for installation.
NOTE: Reader should be oriented with the LED light to the front of the archer and the notched corner to the left.
3) Align cap and slide on gently. There should be little to no resistance until the cap is a 1/4 inch from fully seated.
4) Tighten screws.
NOTE: IF THERE IS ANY QUESTION AS TO IF IT IS GOING TOGETHER CORRECTLY STOP, AND CALL FORT SUPPLY TECH. (435) 760-7688
This video covers the step by step instructions on installing the SDID internal reader. Things you should and should not do are covered to make sure that the user understands how to ensure that the reader does not become dislodged or unusable when the cap is sealed. This video gives examples of removing and replacing the caps, the internal reader placement, padding the cap, and making sure the internal reader registrars with FaST EID